How to Repair a P0116 PT Cruiser 1Use the scan tool to observe the temperature supplied to the laptop or computer by the sensor. Turn the ignition key off and plug the scan tool into the diagnostic port situated under the driver's side from the dash amongst the steering column and driver's side kick panel. Auto tools
Turn the important on and select "DATA" from the menu. Scroll down the sensor information displayed on the scan tool to the "Coolant Temp" sensor reading.2Unplug the coolant sensor located on the front driver's side of your motor. Observe the scan tool sensor reading. In the event the temperature indicates an extremely high temperature (more than 400 degrees) the wiring is fine. If the temperature is very low (below 0 degrees) trace the wiring through the wiring harness until the brief is found and repair it using wire cutters/strippers and butt connectors.
3Start the engine and test the resistance from the sensor making use of a digital volt/ohm meter. Wait 15 minutes and test the resistance. Because the engine heats up the resistance should alter and get higher. Replace the sensor when the resistance does not transform or if infinite resistance is displayed.4Turn the engine off and unscrew the old sensor. Screw the new sensor in and tighten it securely having a socket and ratchet. Erase the difficulty code making use of the scan tool and test drive the auto to verify that the verify engine light does not come back on.
Related articles:
No comments:
Post a Comment